Rear Cross Member Plate

This is the GenRight RBB-1000, a 3/16" thick steel cross member re-enforcement plate to "cap" the factory rear frame cross member on a Jeep TJ, LJ or YJ. It is designed to beef-up your existing rear frame member AND rear most body mounts. It can also be used as a hi clearance bumper by itself (as we do on our swing down tire carriers) or a re-enforcement under any rear bumper. As you can see in the pictures, you remove the rear most body mounts and install the plate then slip them back in place. FEATURES: Allows you to repair or replace damage rear cross members & body mounts (needed on LJ's). Allows you to beef up the factory 1/8" thick rear frame section. Can be installed under an existing rear bumper. Can be used by itself as a bumper for a better departure angle. Bolt-on design Shipped to you un-painted This kit includes: (1) Full width laser cut and CNC bent rear plate No hardware IMPORTANT NOTES: Requires drilling additional holes in the rear cross member to properly mount it on your Jeep. Includes NO hardware with this part number (you can upgrade to RBB-1001). Optional internal "backing plate" is recommended and available (RBB-1007). For proper mounting, it requires removing the fuel tank to drill and access center bolts. Will NOT work on CJ's (please use P/N: RBB1008). If this product is being used under a aftermarket rear bumper to beef up or re-inforce the rear cross member, you may have to cut off and re-weld the lower tabs on the rear bumper (if your bumper has these).